LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Interior Trim) >> Repair Instructions >> Headliner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the interior dome lamp assembly to the new headliner.
    2. Fig 1: Installing Headliner
    GM590175Courtesy of GENERAL MOTORS CORP.
  2. With the aid of an assistant carefully slide the headliner in through the rear of the vehicle.
  3. Secure the headliner to the roof Velcro(R) retainers while aligning the air duct at the right of the third pillar.
  4. Install the retainer through the air outlet louver
  5. Install the air outlet louver by turning clockwise till it is seated in place.
  6. Install the auxiliary climate control assembly. Refer to HVAC CONTROL ASSEMBLY .
  7. Install the assist handles. Refer to Assist Handle Replacement - Rear  .
  8. Install the interior dome lamp. Refer to DOME LAMP REPLACEMENT .
  9. Install the rear coat hook, if equipped. Refer to Coat Hook Replacement  .
  10. Install the sunshade holders to the headliner.
  11. Install the front sunshades. Refer to Sunshade Replacement  .
  12. Connect the electrical connector to the rear view mirror, if needed.
  13. Install the upper console. Refer to Console Replacement - Overhead (Full Length)  or Console Replacement - Overhead (Short Length)  .
  14. Install the rear corner trim pillar moldings. Refer to Garnish Molding Replacement - Rear Corner  .
  15. Install the third pillar trim moldings. Refer to Trim Replacement - Third Pillar (Tahoe/Yukon/Escalade/Suburban)  or Trim Replacement - Third Pillar (Avalanche/Escalade EXT)  .
  16. Install the center trim pillar moldings. Refer to Trim Replacement - Third Pillar (Avalanche/Escalade EXT)  .
  17. Carefully route the wire harness through the IP in order to connect the wire to the junction block located next the brake pedal.
  18. Install the transfer case control module, if equipped. Refer to TRANSFER CASE SHIFT CONTROL MODULE REPLACEMENT .
    19. Fig 2: Wire Harness Retainer
    GM676224Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Please ensure that all of the wire harness retainers in the IP and the windshield pillar are all pressed into place in order to prevent rattling during driving.
  19. Press in the wire harness retainer (1) in order to secure the harness.
    20. Fig 3: Headliner Electrical Connectors
    GM698526Courtesy of GENERAL MOTORS CORP.
  20. Connect the headliner electrical connectors to the junction block located next to the brake pedal.
    21. Fig 4: Drivers Side Accessory Housing
    GM348648Courtesy of GENERAL MOTORS CORP.
  21. Install the drivers side accessory housing (1) to the IP.
  22. Install the sunroof finishing lace, if equipped. Refer to SUNROOF FINISHING LACE REPLACEMENT .
  23. Install the IP top trim panel. Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (IP) UPPER .
scientia non olet · About LEMON Manuals