Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to WHEEL BEARING/HUB REPLACEMENT -- REAR .

Raise and support the vehicle on a suitable hoist.
Remove the rear tire and wheel assembly.
Disconnect the electrical connector from the rear wheel speed sensor.

Fig 1: Rear Wheel Speed Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Remove the hub and bearing assembly (1). Refer to WHEEL BEARING/HUB REPLACEMENT -- REAR

Fig 2: Wheel Hub/Bearing Assembly

Courtesy of GENERAL MOTORS CORP.