LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Antilock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hub and bearing assembly (1) to the vehicle. Refer to Wheel Bearing/Hub Replacement - Rear (Disc Brakes) or Wheel Bearing/Hub Replacement - Rear (Drum Brakes) in Rear.
    Fig 1: View Of Hub And Bearing Assembly
    G01569906Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the rear wheel speed sensor.
    Fig 2: Connecting Electrical Connector To Rear Wheel Speed Sensor
    G01569907Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel and tire assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  4. Lower the vehicle.
  5. Turn the ignition switch to the ON position, with the engine off.
  6. Perform the DIAGNOSTIC SYSTEM CHECK - ABS  .
scientia non olet · About LEMON Manuals