LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1298 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the shroud retaining screws from the back of the steering wheels.
  3. Remove the shroud from the steering wheel.
    Fig 1: Removing Shroud & Retaining Screws From Back Of Steering Wheel
    G01479782Courtesy of GENERAL MOTORS CORP.
  4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.
    Fig 2: Wire Harness Cavity
    G01479783Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the steering wheel control switch electrical connector.
    IMPORTANT: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
  6. Remove the steering wheel control switch from the steering wheel.
    Fig 3: Remove Steering Wheel Control Switch Electrical Connector
    G01479784Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals