Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Use a pry bar in order to install the stabilizer shaft link insulators and the spacer.

Fig 1: View Of Stabilizer Shaft Link Bolt And Nut

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft link and insulators.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the stabilizer shaft link bolt and nut.
Tighten: Tighten the stabilizer shaft link nut to 23 N.m (17 lb ft).
Lower the vehicle.