LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1064 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Bushings Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
  2. Secure the lower control arm in a vice.
    3. Fig 1: Identifying Flat Edge Of The Bushing Flange
    GM623251Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The lower control arm vertical bushing MUST be installed in the same position which it was removed in order to maintain the original vehicle ride, handling and road feel.
  3. Mark the lower control arm along the flat edge of the bushing flange (1).
    4. Fig 2: View Of J 21474-01
    GM381816Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply J 23444-A  (or equivalent high pressure lubricant) to the threads of the J 21474-27 .
  4. Assemble the following bushing tools as shown.
  5. Tighten the J 21474-4 until the bushing is removed from the control arm.
  6. Disassemble the bushing tools.
scientia non olet · About LEMON Manuals