LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek GT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (HVAC Systems - Automatic) >> Removal & Installation >> Blower Motor Control Processor >> Removal

Blower Motor Control Processor: Removal

WARNING: This page is about a different car, the 2002 Pontiac Aztek and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side instrument panel insulator. Disconnect the blower motor electrical connector. See Figure . Remove the blower motor mounting screws.
  2. Remove the blower motor from the HVAC module assembly. Disconnect the electrical connector from the blower motor control processor assembly. See Fig 1 .
  3. Remove the forward blower control processor mounting screws. Remove the rearward blower control processor mounting screw. Remove the blower control processor assembly from the HVAC module assembly. See Fig 2 .
Fig 1: Disconnecting Blower Motor Electrical Connector
G00209243Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Blower Motor Resistor
G00209244Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals