LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Wiper System And Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper arm onto the wiper transmission drive shaft.
    1. 1.1. Align the wiper arm with the marks made on the windshield.
    2. 1.2. Push the wiper arm down onto the wiper transmission drive shaft completely.
    Fig 1: Installing Wiper Arm Onto Wiper Transmission Drive Shaft
    G01476411Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the retaining nut onto the wiper transmission drive shaft and the wiper arm.

    Tighten 

    Tighten the nut to 23 N.m (17 lb ft).

  3. Install the cover on the wiper arm nut.
    Fig 2: Installing Retaining Nut Onto Wiper Transmission Drive Shaft & Wiper Arm
    G01476412Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals