LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 883 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the power steering pump pulley on the end of the power steering pump shaft.
  2. Install the power steering pump pulley using J 25033-C  .
    Fig 1: Identifying Power Steering Pump Pulley Installer For Installing Pump Pulley (SST)
    G01467141Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010 in).
  4. Install the drive belt. Refer to DRIVE BELT REPLACEMENT in Engine Mechanical 2.2L or DRIVE BELT REPLACEMENT in Engine Mechanical 4.3L.
  5. Install the fan clutch. Refer to FAN CLUTCH REPLACEMENT in Engine Cooling.
Fig 2: Checking Power Steering Pump Pulley Attachment Against Power Steering Pump Shaft With Specific Gap
G01467142Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals