LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Self-Diagnostic System >> Body Rear End Diagnostic System Check

Body Rear End Diagnostic System Check

NOTE: The presence of DTCs which begin with "U" indicate some other module on class 2 serial data line is not communicating.
  1. Connect scan tool to Data Link Connector (DLC). DLC is located under left side of instrument panel. If scan tool powers up, go to next step. If scan tool does not power up, go to TEST A: SCAN TOOL DOES NOT POWER UP  under SYSTEM TESTS.
  2. Turn ignition switch to RUN position. Using scan tool, attempt to communicate with Body Control Module (BCM) and Instrument Panel Cluster (IPC). If scan tool communicates with modules, go to next step. If scan tool does not communicate with modules, go to TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE  under SYSTEM TESTS.
  3. Using scan tool, select DISPLAY DTCS function. Retrieve and record any BCM DTCs and their status. If scan tool displays any DTCs, go to next step. If scan tool does not display any DTCs, repair rear lid release by symptom. See POWER DOOR LOCKS & REAR HATCH RELEASE - AZTEK article.
  4. If scan tool does not display any DTCs which begin with a "U", go to next step. If scan tool displays any DTCs which begin with a "U", go to TEST B: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE  under SYSTEM TESTS.
  5. If scan tool does not display DTC B1000 or B1009, go to next step. If scan tool displays DTC B1000 or B1009, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
  6. If scan tool displays DTC B1327, repair engine electrical concern. See appropriate GENERATOR & REGULATOR article in STARTING & CHARGING SYSTEMS. If scan tool displays any other DTCs, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
scientia non olet · About LEMON Manuals