LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 941 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
  2. Disconnect the fuel line from the sending unit. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Disconnect the evaporative emission (EVAP) line from the sending unit. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Using J 45722  remove the sending unit lock ring.
    CAUTION: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the fuel in an open container.
    Fig 1: Removing/Installing Fuel Sending Unit Lock Ring
    GM1302212Courtesy of GENERAL MOTORS CORP.
  5. Remove the sending unit and seal. Discard the seal.
  6. Clean the sending unit sealing surfaces.
scientia non olet · About LEMON Manuals