LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 776 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the power steering pump pulley on the end of the power steering pump shaft.
  2. Install the power steering pump pulley using J 25033-C  .
    Fig 1: Installing Power Steering Pulley
    G01662136Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the power steering pump pulley is flush against the power steering pump shaft, with an allowable variance of 0.25 mm (0.010 in).
    4. Fig 2: Identifying Power Steering Pump Pulley Installation Position
    G01662137Courtesy of GENERAL MOTORS CORP.
  4. Install the drive belt. For 4.8L, 5.3, and 6.0L engines, refer to DRIVE BELT REPLACEMENT -- ACCESSORY or for 8.1L engines, refer to DRIVE BELT REPLACEMENT -- ACCESSORY .
  5. Install the upper fan shroud. Refer to FAN SHROUD REPLACEMENT -- UPPER (W/O M74) or FAN SHROUD REPLACEMENT -- UPPER (W/M74) .
scientia non olet · About LEMON Manuals