LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Power Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat back frame on the seat.
  2. NOTE: Refer to FASTENER NOTICE .
    Fig 1: Installing Inboard Pivot Bolt & Recliner Arm Attachment Bolts
    GM386187Courtesy of GENERAL MOTORS CORP.
  3. Install the recliner arm attachment bolts (2).

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

  4. Install the inboard pivot bolt (1).

    Tighten:  Tighten the bolt to 35 N.m (26 lb ft).

  5. Install the seat belt retractor. Refer to SEAT BELT RETRACTOR REPLACEMENT - LEFT FRONT or SEAT BELT RETRACTOR REPLACEMENT - RIGHT FRONT .
  6. Install the lumbar assembly (or power lumbar/bolster assembly if equipped). Refer to Lumbar Replacement - Front Seat (Manual)  or Lumbar Replacement - Front Seat (Power Lumbar/Bolster) .
  7. Install the seat back trim cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  8. Fig 2: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  9. Connect the lumbar cable (6) underneath the seat cushion (disconnect the wire harness if equipped with power lumbar).
  10. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  11. Install the head restraint and guides. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  12. Install the seat into the vehicle. Refer to Seat Replacement - Front Bucket .