LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 647 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Arm, Cover & Nut
    GM348542Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper arm so that the wiper blade aligns with the mark made on the windshield before removal.
  2. Install the wiper arm onto the drive shaft.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the nut on the drive shaft.

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  4. Install the cover on the nut.
  5. Connect the washer hose.
  6. Clean the locating mark or masking tape from the windshield.
  7. Operate the wipers and inspect for proper operation.
scientia non olet · About LEMON Manuals