LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Front Suspension System) >> Removal & Installation >> Strut Assembly >> Reassembly

Strut Assembly: Reassembly

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place strut in strut compressor with Holding Fixture (J-30413-20) clamped on shaft. Install spring in correct position, and move strut upright. Install upper locking pin. Install upper insulator, spring seat, bearing and strut mount.
  2. Tab on upper spring seat must face out from centerline of vehicle (same direction as steering knuckle mounting flange). Install alignment rod, and compress strut until shaft threads are visible. Install washer and nut. Remove holding fixture from strut shaft. Tighten nut to specification while holding shaft. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals