LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Engine Controls And Fuel - 2.4L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the intake CMP sensor for damage, replace as necessary.
  1. Lubricate the intake CMP sensor O-ring seal with clean engine oil.
  2. Install the intake CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the intake CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Locating Intake Camshaft Position (Cmp) Sensor And Intake Camshaft Position (Cmp) Sensor Connectors
    GM1815154Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the intake CMP sensor.
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals