Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Dust Warning .

CAUTION: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

Fig 1: Brake Caliper Guide Pin Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE:

DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolt. DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the brake caliper will cause a pulsation when the brakes are applied.

Remove the brake caliper guide pin bolts (1).
Hold the brake caliper guide pins stationary when removing the guide pin bolts.
Without disconnecting the brake caliper hose, remove the brake caliper and support with heavy mechanics wire or equivalent.

Fig 2: Upper And Lower Guide Pins

Courtesy of GENERAL MOTORS CORP.

Remove the upper and lower guide pins (1).
Remove the upper and lower guide pin seals (2).