LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1529 (Wipers System And Washer System) >> Repair Instructions >> Washer Pump/Reservoir Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not reuse washer solvent as debris may clog the system.
    Fig 1: Removing/Installing Washer Solvent Filter Grommet
    GM929316Courtesy of GENERAL MOTORS CORP.
  1. Connect the front and rear washer solvent hoses to the washer pump.
  2. Install the washer pump into the washer solvent container. Ensure the washer pump filter is installed, if removed.
  3. Connect the washer pump electrical connector.
  4. Insert the front and rear washer solvent container hoses into the grooves in the solvent container.
    5. IMPORTANT: Washer solvent container grommet must be installed between container and body structure to prevent squeaks and rattles.
  5. Install the washer solvent container into the motor compartment. Ensure that the washer solvent container's mounting peg, with grommet installed, is seated into the mounting hole in the body structure. A lubricant may be used to ease installation.
  6. Connect the front washer solvent container hose to front nozzle hose that runs along the upper motor compartment rail.
    7. Fig 2: View Of Washer Pump/Reservoir
    GM931356Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  7. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  8. Position coolant surge tank back into correct location.
  9. Install the coolant surge tank bolts.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

  10. Fill the washer solvent container with washer solvent.
scientia non olet · About LEMON Manuals