LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1319 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm & Outer Tie Rod Ball Stud
    GM65333Courtesy of GENERAL MOTORS CORP.
  1. Install steering knuckle to the upper control arm and the lower control arm. Refer to Upper Control Arm Replacement  and Lower Control Arm Replacement .
  2. Remove the jackstand.
  3. Install the steering linkage outer tie rod ball stud to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering Systems.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the stabilizer shaft link to the lower control arm.

    Tighten:  Tighten the stabilizer shaft link nut to 72 N.m (53 lb ft).

    5. Fig 2: View Of Rear Wheel Speed Sensor Harness Connector
    GM581404Courtesy of GENERAL MOTORS CORP.
  5. Connect the wheel speed sensor electrical connector.
  6. Install the brake rotor and caliper. Refer to Brake Rotor Replacement - Front and Brake Caliper Replacement - Front in Disc Brakes.
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Check the front wheel toe and adjust as necessary. Refer to Diagnostic Starting Point - Disc BrakesMeasuring Wheel Alignment in Wheel Alignment.
scientia non olet · About LEMON Manuals