LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1284 (Horn System) >> Repair Instructions >> Horn Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Horn Assembly At Skid Bar
    GM65138Courtesy of GENERAL MOTORS CORP.
  1. Position the horn assembly to the skid bar.

    Install the aligning tab on the horn assembly into the hole on the skid bar.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the horn assembly bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Horn Assembly Electrical Connector
    GM65137Courtesy of GENERAL MOTORS CORP.
  3. Connect the horn assembly electrical connector.
  4. Install the right front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
scientia non olet · About LEMON Manuals