Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the carpet over the floor.
- Install the carpet air outlet into the carpet to the passenger side only.
- Rotate the air outlet 45 degrees counterclockwise and insert the outlet into the front of the carpet.
- Rotate the air outlet 45 degrees clockwise to lock in position.
- Connect the air duct to the carpet air outlet on the passenger side only.
- Tuck the carpet under the accelerator pedal.
- Install the accelerator pedal stop.
Tighten: Tighten the stop nuts to 10 N.m (89 lb in).
- Install the driver side foot rest.
Tighten: Tighten the foot rest nuts to 10 N.m (89 lb in).
- Tuck the carpet under the instrument panel and accessory trim plate.
- Pull the seat electrical connector through the slit in the carpet.
- Install the floor kick-up panel on the passenger side only. Refer to Kick-Up Panel Replacement - Front Floor .
- Install the side sill trim plate. Refer to Door Sill Plate Replacement .
- Reposition the intermediate carpet over the floor carpet.
- Install the seat. Refer to Seat Replacement (Power) or Seat Replacement (Manual) in Seats.
CAUTION:
In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.
NOTE:
Refer to Fastener Notice in Cautions and Notices.