LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1083 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Washer Solvent Container Screws
    GM697662Courtesy of GENERAL MOTORS CORP.
  1. Position the washer solvent container to the right side engine compartment.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    3. Fig 2: View Of Washer Solvent Container Level Sensor Electrical Connector
    GM774666Courtesy of GENERAL MOTORS CORP.
  3. Connect the washer solvent container level sensor electrical connector.
    4. Fig 3: View Of Washer Solvent Container Components
    GM771826Courtesy of GENERAL MOTORS CORP.
  4. Connect the rear washer pump electrical connector if equipped.
  5. Connect the washer hose to the rear washer pump if equipped.
    6. Fig 4: Identifying Front Washer Pump Electrical Connector
    GM697664Courtesy of GENERAL MOTORS CORP.
  6. Connect the front washer pump electrical connector.
  7. Connect the front washer hose to the front washer pump.
  8. Fill the washer solvent container with washer solvent.
  9. Install the battery. Refer to Battery Replacement in Engine Electrical.
scientia non olet · About LEMON Manuals