LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Body Front End) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hood hinge to the fender.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the hood hinge to fender bolts.

    Tighten:  Tighten the hood hinge to fender bolts to 6 N.m (53 lb in).

    Fig 1: View Of Hood Hinge To Fender Bolts
    GM617956Courtesy of GENERAL MOTORS CORP.
  3. Install the hood. Refer to Hood Replacement .
  4. Install the hood assist rod. Refer to Assist Rod Replacement - Hood .
  5. Install the hood rear side seal. Refer to Seal Replacement - Hood Rear Side .
  6. Adjust the hood, as required. Refer to Hood Adjustment .
scientia non olet · About LEMON Manuals