Wiper/Washer System
- Turn ignition switch to RUN position. Hold washer switch on for 1-2 seconds. Washer should spray until switch is released. Wipers should operate for 3 cycles after washer cycle is complete. Wipers should return to park position.
- Turn wiper switch to LOW position. Wipers should continue to operate at low speed. Turn wiper switch to HIGH position. Wipers should operate at high speed. Turn wiper switch to OFF position. Wipers should return to park position. Turn wiper switch to MIST position, then release. Wipers should make one complete sweep and return to park position. If wiper system does not function properly, perform appropriate symptom test. See SYMPTOM INDEX table under SYSTEM TESTS.