Test 2: Left Front Window Inoperative
NOTE:
Master window switch on 2-door models has only one connector. Master window switch on 4-door models has 2 connectors.
- Turn ignition switch to RUN position. On 2-door models, connect a test light (backprobe) between ground and master window switch connector C1 terminal "D" (Dark Blue wire). On 4-door models, connect a test light (backprobe) between ground and master window switch connector C1 terminal "E" (Dark Blue wire). See Figure . On all models, press left front window switch to UP position. If test light comes on, go to next step. If test light does not come on, go to step 4 .
- On 2-door models, connect a test light (backprobe) between ground and master window switch connector C1 terminal "E" (Gray wire). On 4-door models, connect a test light (backprobe) between ground and master window switch connector C1 terminal "D" (Gray wire). On all models, press left front window switch to DOWN position. If test light comes on, go to next step. If test light does not come on, go to step 4 .
- Disconnect left front window motor. Using test light connected to ground, probe left front window motor connector terminal "A" (Dark Blue wire). Press master window switch to UP position. If test light comes on, go to step 5 . If test light does not come on, go to step 6 .
- Replace master window switch. See WINDOW SWITCH under REMOVAL & INSTALLATION. After repair is complete, retest system.
- Using test light connected to ground, probe left front window motor connector terminal "B" (Gray wire). Press left front window switch to DOWN position. If test light comes on, go to step 7 . If test light does not come on, go to step 8 .
- Repair open in Dark Blue wire between master window switch and left front window motor. See WIRING DIAGRAMS . After repair is complete, retest system.
- Replace left front window motor. See WINDOW MOTOR under REMOVAL & INSTALLATION. After repair is complete, retest system.
- Repair open in Gray wire between master window switch and left front window motor. See WIRING DIAGRAMS . After repair is complete, retest system.