Installation (5.7L)

To install, reverse removal procedure. Lubricate NEW injector "O" rings with clean engine oil. Install injector-to-fuel rail retaining clip on right side of injector harness connection. Position fuel rail on intake manifold. Push down on rail to seat injectors in manifold. Tighten fuel rail retaining bolts. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.

Fig 1: Locating Fuel Rail Assembly Components (1.9L - VIN 7 Shown; VIN 8 Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating Fuel Rail Assembly Components (2.2L - VIN F)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Locating Fuel Rail Assembly Components (2.2L - VIN 4)

Courtesy of GENERAL MOTORS CORP.

Fig 4: Locating Fuel Rail Assembly Components (2.4L - VIN T)

Courtesy of GENERAL MOTORS CORP.

Fig 5: Locating Fuel Rail Assembly Components (3.0L - VIN R)

Courtesy of GENERAL MOTORS CORP.

Fig 6: Locating Fuel Rail Assembly Components (3.1L - VIN M & 3.4L - VIN E)

Courtesy of GENERAL MOTORS CORP.

Fig 7: Locating Fuel Rail Assembly Components (3.5L - VIN H)

Courtesy of GENERAL MOTORS CORP.

Fig 8: Locating Fuel Rail Assembly Components (3.8L - VIN K)

Courtesy of GENERAL MOTORS CORP.

Fig 9: Locating Fuel Rail Assembly Components (3.8L - VIN 1)

Courtesy of GENERAL MOTORS CORP.

Fig 10: Locating Fuel Rail Assembly Components (4.6L - VIN Y & 9)

Courtesy of GENERAL MOTORS CORP.

Fig 11: Locating Fuel Rail Assembly Components (5.7L - VIN G)

Courtesy of GENERAL MOTORS CORP.