Cooling Fan Motor
Disconnect cooling fan motor harness connector. Apply battery voltage to one of the fan motor terminals and jumper the other terminal to ground. Fan motor should activate. If fan motor does not activate, replace faulty fan motor.
COOLING FAN RELAY LOCATION
| Application | Location |
|---|---|
| "U" Series | Behind Right Headlight, Near Fuel Evaporative Canister |
NOTE:
For a more specific system testing, refer to the following C-12 diagnostic tests. If any test other than a C-12 test is referenced, see appropriate TESTS W/CODES
article.
NOTE:
Tests requires use of Tech 1 Scan Tool (TK O-A) and Cartridge Kit (7000001), Tech 1 OBD II Vehicle Interface Module Kit (7000041). Other scan tools are available, refer to tester manufacturer for compatibility to vehicle system being tested.