Band Apply Pin Selection Check
- Install Band Apply Pin Gauge (J-28535) over intermediate servo bore, and retain it with 2 servo cover bolts. See Fig 1 . Remove band apply pin from intermediate servo assembly.
- Install Band Apply Pin Gauge Extension (J-28535-4) onto servo piston end of band apply pin. Install band apply pin and gauge extension into gauge on servo bore.
- Using an INCH-lb. torque wrench, apply torque of 100 INCH lbs. (11.3 N.m) to hex nut on gauge tool. If pin is correct size, White line on gauge extension will appear in window.
- If White line does not appear in window, use a longer or shorter pin as necessary. See INTERMEDIATE BAND APPLY PIN . Repeat step 3) to ensure pin size is correct. Set selected pin aside until transaxle reassembly procedure.
INTERMEDIATE BAND APPLY PIN
| Length | Identification |
|---|---|
| Short | 2 Grooves |
| Medium | 1 Groove |
| Long | No Groove |