Wipers Do Not Operate When Washer Switch Is Activated
- Turn ignition switch to RUN position. Connect test light between wiper/washer switch connector terminal "E" (Dark Green wire) and ground. Activate washer switch while watching test light.
- If test light is on, go to next step. If test light is off, check for open Dark Green wire in wiper/washer switch pigtail and switch connector. If wire is okay, replace wiper/washer switch.
- Check for open in Dark Green wire between wiper/washer switch connector and wiper motor. If wire is okay, replace wiper motor cover (circuit board). See Figure .