Code 22: TPS Signal Volt Low: Notes
- Code 22 will set if TPS signal voltage is less than about .2 volt for 3 seconds and the engine running. This test confirms Code 22 is present.
- Simulates Code 21. If the ECM recognizes the high signal voltage and sets Code 21, the ECM and wiring are okay.
- With throttle closed, the TPS voltage reading should be at idle specification. See DIAGNOSTIC AIDS.
- This simulates a high signal voltage to check for an open in circuit No. 417.
- On some models a buffered 5-volt throttle position sensor reference circuit is shared by the MAP sensor. If either of these circuits is shorted to ground, a Code 22 will set. To determine if the MAP sensor is causing the Code 22, disconnect the MAP sensor and see if Code 22 is reset.