By-Pass Wire

When an engine speed signal of approximately 400 RPM is received by the ECM, ECM considers engine to be running and applies 5 volts to the ignition module on the by-pass wire. This causes ignition module to switch timing control over to the variable timing control circuit in the ECM. On some models, this by-pass wire contains a connector located between the 4-wire connector and the ECM. This is disconnected when adjusting base timing. On all models, an open or grounded by-pass circuit will set a Code 42 in ECM memory. The engine will run at base timing plus a small amount of advance built into the HEI module.