Front Window Motor & Regulator: Notes

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly. Lock sector gear to back plate by drilling a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .

WARNING: To prevent personal injury, before removing regulator from motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Figure .