Pump Rod
Make certain pump rod connected in correct hole of pump lever (see Specifications ). With throttle valves completely closed, measure from top of choke valve wall (next to vent stack) to top of pump stem. Distance should be as specified in Specification table. Adjust by bending pump lever as follows: Wedge lever with a screwdriver, tighten a crescent wrench securely on lever and bend lever downward (if specification too small), bend lever upward (if specification too large).
CAUTION:
To make certain throttle valves are completely closed when checking pump rod, it is recommended that actuating link between primary and secondary throttle lever be disconnected for this check.