LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 2000 >> Voyager Base, 3.0 3 >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Power Door Locks/RKE System >> Driver's Door Key CYL Arm SW Failure

Driver's Door Key CYL Arm SW Failure

  1. Using scan tool, clear any diagnostic trouble codes. Using scan tool, read driver's door zone switch voltage. If DRIVER'S DOOR ZONE SWITCH voltage is about 4 volts, inspect for binding driver's door key lock. Replace key lock as necessary. If DRIVER'S DOOR ZONE SWITCH voltage is not about 4 volts, go to next step.
  2. Turn driver's door key cylinder switch to lock position and observe driver's door zone switch voltage on scan tool. Do not hold key in lock position for more than 7 seconds or code will set. If DRIVER'S DOOR ZONE SWITCH voltage is about 4 volts, go to next step. If DRIVER'S DOOR ZONE SWITCH voltage is not about 4 volts, replace driver's door key cylinder switch.
  3. Operate driver's door key lock cylinder several times from unlock to lock position. Release key lock cylinder. With key lock cylinder in neutral position, observe scan tool voltage. If DRIVER'S DOOR ZONE SWITCH voltage is about 5 volts, system is functioning properly at this time. Fault may be intermittent. If DRIVER'S DOOR ZONE SWITCH voltage is not about 5 volts, replace driver's door key cylinder switch.
scientia non olet · About LEMON Manuals