Power Window & Vent Switch

Remove the desired switch to be tested from the door trim panel. Driver's side (master) or passenger side. See POWER WINDOW SWITCH & BEZEL ASSEMBLY under REMOVAL & INSTALLATION.
Using an ohmmeter, test driver door switch for continuity. See POWER WINDOW MASTER SWITCH TEST . For door switch terminal identification, see Fig 1 .
Test passenger door switch for continuity. See Fig 2 . If the results are not as specified, replace the switch.

POWER WINDOW MASTER SWITCH TEST

Switch Position

Continuity Between Terminals

OFF

13 & 1

OFF

13 & 2

OFF

13 & 3

OFF

13 & 4

OFF

13 & 5

OFF

13 & 6

OFF

13 & 7

OFF

13 & 8

Up Driver

11 & 8

Down Driver ⁽¹⁾

11 & 6

Up Passenger

9 & 4

Down Passenger

9 & 2

Left Vent Open

11 & 7

Left Vent Close

9 & 3

Right Vent Open

9 & 1

Right Vent Close

11 & 5

⁽¹⁾	Must test with B+ on terminal No. 9 and ground on terminal No. 13 for continuity between terminals No. 6 and 11.

Fig 1: Identifying Power Window Master Switch Connector Terminals

Courtesy of CHRYSLER CORP.

Fig 2: Testing Passenger Door Power Window Switch Continuity

Courtesy of CHRYSLER CORP.