Engine Controls - Service & Adjustment Specifications - 3.3L: Capacities

BATTERY SPECIFICATIONS

Application & Group	Cold Cranking Amps	Amp Hr. Rating
FWD Van
Caravan 3.3L (Group 34)	500	60
Town & Country 3.3L (Group 34)	500	60
Voyager 3.3L (Group 34)	500	60

FLUID CAPACITIES

Application

⁽¹⁾ Quantity

Crankcase (Includes Filter) ⁽²⁾

4.5 Qts. (4.3L)

Cooling System ⁽³⁾

13.2 Qts. (12.5L)

Automatic Transaxle (Mopar ATF Plus Type 7176)

3-Speed

Drain & Refill

⁽⁴⁾ 4.0 Qts. (3.8L)

Dry Refill

8.5 Qts. (8.0L)

4-Speed

Drain & Refill

⁽⁴⁾ 4.0 Qts. (3.8L)

Dry Refill

9.1 Qts. (8.6L)

Overrunning Clutch (Mopar ATF Plus Type 7176)

AWD Models

⁽⁵⁾

Power Steering Fluid ⁽⁶⁾

1.7 Pts. (.8L)

Power Transfer Unit (SAE 80W-90/API GL-5)

AWD Models

1.2 Qts. (1.14L)

Rear Differential (SAE 80W-90/API GL-5) ⁽⁵⁾

AWD Models

⁽⁷⁾

⁽¹⁾	Approximate quantity listed.

⁽²⁾

Use an API energy conserving engine oil that is certified for gasoline engines on all engines except 3.3L flex-fuel models. On 3.3L flex-fuel models, use Mopar Flex-Fuel 5W-30 engine oil or an equivalent that meets Chrysler Standard MS-9214. Proper engine oil MUST BE used to prevent engine damage. The 3.3L flex-fuel model may be referred to as Flex-Fuel Vehicle (FFV) model and is used in all vehicles except California emission vehicles. Flex-fuel model may be also referred to as an E85 application and may be identified by label attached to inside of gasoline filler door.

⁽³⁾	Quantity includes heater and coolant recovery tank. Add 2 qts. (1.9L) if equipped with rear heater.

⁽⁴⁾

Add this amount of fluid. Start engine and shift transaxle through all gears and back to Park. Add additional fluid to bring fluid level to 1/8" below the ADD mark on dipstick. Recheck fluid level with transaxle at normal operating temperature. Adjust fluid level so fluid level is within the HOT range dipstick.

⁽⁵⁾

An overrunning clutch is bolted on front of rear differential, between torque tube for drive shaft and rear differential. Overrunning clutch contains a separate reservoir from rear differential. Ensure fluids are checked at appropriate component, as different types of fluids are used. Fluid capacity is not available from manufacturer.

⁽⁶⁾	Use only Mopar power steering fluid. DO NOT use automatic transmission fluid.

⁽⁷⁾	Capacity not available from manufacturer. Fill unit until fluid level is even with bottom of filler plug hole.