Door Ajar Test 11A - Left Sliding Door Ajar Open Circuit
NOTE:
Perform DOOR AJAR TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
- Disconnect left sliding door ajar switch and ensure connector is clean and not damaged. Ensure door ajar switch ground strap is clean and not damaged. Repair or replace ground strap as necessary. If ground strap is okay, go to next step.
- Connect a jumper wire between left sliding door ajar switch connector (Tan/Orange wire) and chassis ground. Using scan tool, read left sliding door ajar switch status. If scan tool displays LSLIDE DR AJAR: CLOSED, replace door ajar switch. If scan tool does not display LSLIDE DR AJAR: CLOSED, go to next step.
- Disconnect jumper wire. Locate Body Control Module (BCM) connector "B". BCM is located with junction block under driver's side instrument panel. See Figure . Remove connector cover. Do not disconnect connector. Connect jumper wire between chassis ground and terminal No. 47 (Tan/Orange wire). Using scan tool, read left front door ajar switch status. If scan tool displays LSLIDE DR AJAR SWITCH: CLOSED, repair open in Tan/Orange wire between left sliding door ajar switch and BCM. If scan tool does not display LSLIDE DR AJAR SWITCH: CLOSED, replace BCM.