LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1998 >> Voyager Base, 3.3 R >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Computer Tests >> Chime Test 6A - Chime Inoperative With Exterior Lights On

Chime Test 6A - Chime Inoperative With Exterior Lights On

NOTE: Perform CHIME TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Ensure all exterior lights are functioning properly. If any exterior lights do not illuminate, go to EXTERIOR LIGHT TEST 1A  . If all lights are functioning, go to next step.
  2. Open driver's door. Using scan tool, read door ajar status. If scan tool displays DRDOOR AJAR SWITCH: CLOSED, go to next step. If scan tool does not display DRDOOR AJAR SWITCH: CLOSED, go to DOOR AJAR TEST 3A  .
  3. Remove ignition key. Using scan tool, read key-in ignition switch status. If scan tool does not display KEY-IN IGNITION SW: OPEN, go to CHIME TEST 4B  . If scan tool displays KEY-IN IGNITION SW: OPEN, go to next step.
  4. Turn on parking lights. If chime does not sound, replace Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Figure . If chime sounds, turn on headlights. If chime does not sound, replace BCM. If chime sounds, system is currently functioning correctly.
scientia non olet · About LEMON Manuals