Window Switch Continuity Test

Remove switch from door trim panel. See WINDOW SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check switch continuity. See appropriate WINDOW SWITCH CONTINUITY TEST table. If there is no continuity at any one of the switch positions, replace switch. See Fig 1 or Fig 2 .

Fig 1: Identifying Driver's Window Switch Terminals (Caravan, Town & Country, & Voyager)

Courtesy of CHRYSLER CORP.

Fig 2: Identifying Passenger Window Switch & Vent Switch Terminals (Caravan, Town & Country, & Voyager)

Courtesy of CHRYSLER CORP.

DRIVER'S WINDOW SWITCH CONTINUITY TEST

Switch Position

Continuity Between Pins No.

Off

1 & 13; 2 & 13; 3 & 13; 4 & 13; 5 & 13; 6 & 13, 7 & 13; 8 & 13

Driver Side

8 & 11

Passenger Side

4 & 9

Down

Driver Side ⁽¹⁾

6 & 11

Passenger Side

2 & 9

Auto-Down

Driver Side ⁽¹⁾

6 & 11

Vent Open

Left

7 & 11

Right

1 & 9

Vent Close

Left

3 & 9

Right

5 & 11

⁽¹⁾	Connect battery voltage to terminal No. 11 and ground to terminal No. 13 before testing.

PASSENGER WINDOW SWITCH CONTINUITY TEST

Switch Position	Continuity Between Pins No.
Off	2 & 5; 3 & 8
Up	4 & 8
Down	4 & 5