Test 8E - Short To 5 Volts
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
section at the end of this article.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
Using scan tool in ohmmeter mode, check resistance at instrument cluster connector, ground circuit (Black/Light Green wire). If resistance is more than 5 ohms, repair open Black/Light Green wire. Perform TEST VER-1. If resistance is less than 5 ohms, replace MIC or EIC. Perform TEST VER-1.