LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1995 >> Neon Base, 4D Sedan, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 2F >> Solenoid & Modulator Circuits

Solenoid & Modulator Circuits

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see wiring diagram.
  1. Stop actuator test. Turn ignition off. Disconnect CAB 60-pin connector. Inspect, clean and repair connector as necessary. Perform TEST VER-1A. If connector is okay, use scan tool in ohmmeter mode to check resistance of CAB connector terminal No. 48 (Dark Blue/Light Blue wire). If resistance is less than 5 ohms, repair short to ground in Dark Blue/Light Blue wire. Perform TEST VER-1A. If resistance is more than 5 ohms, go to next step.
  2. Reconnect HCU 6-pin connector. Using scan tool, check resistance of CAB connector terminal No. 48 (Dark Blue/Light Blue wire). If resistance is more than 5 ohms, repair open in Dark Blue/Light Blue wire. Perform TEST VER-1A. If resistance is less than 5 ohms, go to TEST 20A.
scientia non olet · About LEMON Manuals