Service Precautions

During diagnosis, following these precautions:

• Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components. See FUEL PRESSURE RELEASE  .
• When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section before disconnecting battery.
• Vehicle must have a fully charged battery and functional charging system.
• Probe PCM 60-pin connector from pin side. DO NOT backprobe PCM connector.
• DO NOT cause short circuits when performing electrical tests. This will set additional trouble codes, making diagnosis of original problem more difficult.
• DO NOT use a test light instead of a voltmeter.
• When checking for spark, ensure coil wire is no more than 1/4" from ground. If coil wire is more than 1/4" from ground, damage to vehicle electronics and/or PCM may result.
• DO NOT prolong testing of fuel injectors, or engine may hydrostatically (liquid) lock.
• Always repair lowest trouble code number (CHECK ENGINE light) or first trouble code displayed (DRB) first.
• Always perform verification procedure test after repairs are made.
• Always disconnect DRB after use.
• Always disconnect DRB before charging battery.