Fuel Pressure Release
CAUTION:
ALWAYS relieve pressure before disconnecting any fuel injection-related components. DO NOT
allow fuel to contact engine or electrical components.
- Loosen fuel filler cap to release tank pressure. Disconnect injector wiring harness from engine harness. Connect a jumper wire between terminal No. 1 of injector harness connector and engine ground. See Fig 1 .
- Connect one end of second jumper wire to terminal No. 2 of injector harness connector, and touch other end to battery positive for no more than 5 seconds. This releases system pressure. Remove jumper wires.
WARNING:
Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT
allow fuel to contact engine or electrical components.