Test 7B - Short To Battery
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using an external ohmmeter, check resistance between PCM connector terminal No. 26, CCD bus positive circuit (Violet/Brown wire), and terminal No. 7, 8-volt supply circuit (Orange wire). If resistance is less than 5 ohms, repair short between Violet/Brown and Orange wires. Perform TEST VER-1.
- If resistance is more than 5 ohms, check resistance between PCM connector terminal No. 46, CCD bus negative circuit (White/Black wire), and terminal No. 7, 8-volt supply circuit (Orange wire).
- If resistance is less than 5 ohms, repair short between White/Black and Orange wires. Perform TEST VER-1. If resistance is more than 5 ohms, replace PCM. Perform TEST VER-1.