Verification Procedure 2

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If another fault was read previously and not corrected, return to TEST FC-1A  and follow path specified by other fault. If Powertrain Control Module (PCM) has not been replaced, perform following:

• Connect DRB-II to data link connector, and erase faults.
• Using DRB-II, reset all values in adaptive memory.
• Disconnect DRB-II.

To ensure no other fault remains, perform following:

1) Turn on A/C and blower motor (if equipped). Drive vehicle at least 5 minutes and attain a speed of at least 40 MPH. Ensure transmission shifts through all gears.

2) Upon completion of road test, turn engine off. Restart engine, and let it idle for at least 2 minutes. Turn engine off. Connect DRB-II to data link connector.

3) Read all fault messages. If repaired fault has reset, repair is not complete. Check all pertinent TECHNICAL SERVICE BULLETINS (TSBs), and return to TEST FC-1A  if necessary. If another fault exists, return to TEST FC-1A and follow path specified by other fault. If no other faults exist, repair is now complete.