LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1992 >> Voyager Base, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - Gasoline >> Ignition System >> Distributor (3.0L Optical) >> Installation

Distributor (3.0L Optical): Installation

  1. Position distributor in engine. Ensure "O" ring is properly seated on distributor. Replace "O" ring if it is cracked or nicked.
  2. Carefully engage distributor drive with camshaft drive so, when distributor is installed properly, rotor aligns with reference mark on intake plenum.
  3. Install distributor cap. Check all high tension wires for good connections. Install and finger-tighten hold-down nut. Connect distributor lead wire at wiring harness connector. Set ignition timing.
scientia non olet · About LEMON Manuals