Test Ch-VER, Charging Verification
- Inspect and ensure all engine components are connected.
- If SBEC has been changed and if vehicle is equipped with a factory theft alarm, start vehicle at least 20 times so alarm will activate when desired. If vehicle is a minivan or truck body, write Emission Maintenance Reminder (EMR) mileage into new SBEC.
- Connect DRB-II to engine diagnostic and erase faults.
- Ensure no other charging system problems remain by doing the following:
- Start engine.
- Raise engine speed to 2000 RPM for at least 30 seconds.
- Allow engine to idle.
- Turn engine off.
- Turn ignition on.
- With DRB-II, read fault messages.
- If repaired fault has reset, repair is incomplete. Check all pertinent TECHNICAL SERVICE BULLETINS and return to TEST CH-1, BATTERY TEST if necessary. If there are no other faults, repair is complete.