LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1992 >> Voyager Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Bleeding Brake System >> Manual Bleeding

Manual Bleeding

NOTE: Manual bleeding procedure may require a second technician.
  1. Ensure ignition remains in OFF position during brake bleeding procedure. Depressurize accumulator by pumping brake pedal at least 40 times. When a definite increase in pedal effort is felt, pump pedal a few more times to ensure pressure is released.
  2. Connect transparent hose to LR caliper/wheel cylinder bleed screw. Submerge free end of hose in clear jar partially filled with clean brake fluid. Slowly pump brake pedal full strokes several times; allow about 5 seconds between pedal strokes. After 2 or 3 strokes, hold pedal at bottom of travel.
  3. With pressure on pedal, open caliper/wheel cylinder bleed screw 1/2 - 3/4 turn. Leave bleed screw open until fluid no longer flows from hose, or fluid level stops rising in bottle. Tighten bleed screw, and release pedal. Repeat procedure until clear, bubble-free fluid flows from hose. Bleed calipers/wheel cylinders in the following order: LR, RR, LF and RF.
scientia non olet · About LEMON Manuals