Engine Controls - Remove/Install/Overhaul: Turbocharger: Removal
- From top of engine, remove front engine mount through bolt. Rotate engine top away from cowl. Disconnect coolant line from water box and turbocharger housing. Remove line and fitting from turbocharger.
- Disconnect oil feed line from turbocharger housing. Remove wastegate rod retaining clip. Remove 3 nuts (2 upper, one lower on driver's side) retaining turbocharger to manifold.
- Disconnect O2 sensor electrical connector. Disconnect vacuum lines. Remove right front wheel and driveshaft. From under vehicle, remove support bracket between turbocharger and block.
- Disconnect oil drain back tube fitting from turbocharger housing. Remove fitting and hose. Remove last turbocharger attaching nut. Disconnect exhaust pipe joint from turbocharger housing.
- Remove lower coolant line and turbocharger inlet fitting. From under vehicle, remove turbocharger.