Cruise Control Switch: Installation

On standard column models, insert harness connector through turn signal lever opening in column. Pull harness down and out lower end.
On tilt column models, insert harness through turn signal lever opening in column and pull upward through upper housing. Attach guide wire to switch wiring harness and gently pull downward through column opening, between lock plate and side of housing.
On all models, use care to avoid damaging wires and to remove all slack from harness. On tilt column models, remove guide wire. On all models, install wiring trough and snap 4 plastic retainer clips in place.
On RWD models with tilt column, install 4 screws retaining steering column support bracket to column jacket. Position column assembly on 2 support studs and install and tighten nuts on 2 studs.
On all models, connect cruise control switch electrical connector to instrument panel harness connector. Install 2 screws attaching cruise control switch to column.
On all models, install lower steering column cover. Connect negative battery cable and test operation of cruise control.